设为首页加入收藏
图片
栏目导航
 
 
点评搜索
 
 
点评详情
发布于:2019-9-11 06:05:05  访问:125 次 回复:0 篇
版主管理 | 推荐 | 删除 | 删除并扣分
The Procedure Of Eliminating A Installed Car Stereo
Starting along with your digital multimeter, locate the power sources in the harness. One source will soon be constant 12 volts, another is going to be the ACC (ignition) 12 volts. These two will go together with the yellow and red wires from the harness of the aftermarket head unit. They can be labeled accordingly. Lots of head units have a connector for this already connected to the ground wire. Secure these in place with some solder and shrink tube. Ease the shrink tubing over one of the cables to be connected and move it out of the way. Connect the cables and dab on a little solder on the cables. Let cool and after that slide the heat shrink tubing within the connection.
The other way you`ll be able to follow down the loudspeakers will be to turn on the head unit, but be VERY careful not to cross any cables. Note which speaker it is and attach it to that speaker`s cables from the wiring harness, taking not of polarity. Continue until all of the wires are in place. Zip tuck them and tie the cable together. Be sure you have a ground wire connection that is good. Be certain that signal wires or RCAs are running away from sources or any electricity cables, and aren`t run parallel.
You can attempt to look on the net for the wiring colours, but good luck. They will tell you the \"typical\" wire colours, but chances are it is going to vary. Two techniques can attempt to get the correct cables. Clip the rest of the cables from the factory harness. It is possible to analyze the speakers having a good 9 volt battery to find out which loudspeakers are which. Two wires connected to the same loudspeaker will ensure it is pop. I prefer to turn on the unit and also make sure that the cables would be the correct polarity. A reverse wired speaker will not have as good a sound as a properly wired one. Until each of the speakers are joined continue the technique.
Because an in dash unit that fits your auto is being bought by you, you`ll be given an installation kit that will include all of the hardware required for the setup. This can help ensure that there are no differences involving the system and the dash. You are going to discover a connector with acceptable span to achieve this. For those who have almost any inquiries relating to where and how to employ Adapter für Lenkradfernbedienung, you are able to contact us with the site. CB antennas or Power antennas might be deemed necessary. The last testing is done with evaluation discs to optimize the sound.
You will not detect them in the day, although take note, that anytime the unit is on, the dashboard panel lights are going to be on too. Not having the wiring harness for the car just isn`t a do or die situation. Save the hassle and time if you`re able to get the harnesses and use it.
Car stereos are installed in automobiles to make the driving pleasing and comfortable. For most of the people now a car stereo is a vital element in their car. They can be placed in the center of the vehicle sound system and are shaped and fitted as to match the interiors of the car.
共0篇回复 每页10篇 页次:1/1
共0篇回复 每页10篇 页次:1/1
我要回复
回复内容
验 证 码
看不清?更换一张
匿名发表 
图片
脚注信息
版权所有 Copyright(C)山东省临清市福寿长空心挂面厂






友情链接:第一环评网 环保 数字化展厅 烟台大樱桃 天猫网购商城